Extension Cord Cable Size; Electric Motor Loads; Electrical; Generator Capacity - Homelite UT905700 Serie Manual Del Operador

EXTENSION CORD CABLE SIZE

Refer to the table below to ensure the cable size of the extension cords you use are capable of carrying the required load.
Inadequate size cables can cause a voltage drop, which can burn out the appliance and overheat the cord.
Load in Watts
Current in
Amperes
At 120V
2.5 300
5 600
7.5 900
10 1200
15 1800
20 2400
25 3000
30 3600
40 4800

ELECTRIC MOTOR LOADS

It is characteristic of common electric motors in normal operation to draw up to six times their running current while start-
ing. This table may be used to estimate the watts required to start "Code G" electric motors; however, if an electric motor
fails to start or reach running speed, turn off the appliance or tool immediately to avoid equipment damage. Always check
the requirements of the tool or appliance being used compared to the rated output of the generator.
Motor Size (H.P.)
1/8
1/6
1/4
1/3
1/2
3/4
1
CAUTION:
Operating voltage and frequency requirement of all
electronic equipment should be checked prior to plugging
them into this generator. Damage may result if the
equipment is not designed to operate within a +/- 10%
voltage variation, and +/- 3 hz frequency variation from the
generator name plate ratings. To avoid damage, always
have an additional load plugged into the generator if
solid state equipment (such as a television set) is used.
A power line conditioner is recommended for some solid
state applications.

ELECTRICAL

At 240V #8 Wire
600
1200
1800
2400
3600
4800 175 ft.
6000 150 ft.
7200 125 ft.
9600 90 ft.
Running Watts
Repulsion Induction
275
275
400
450
600
850
1100
Page 8 — English
Maximum Allowable Cord Length
#10 Wire #12 Wire
1000 ft. 600 ft.
500 ft. 300 ft.
350 ft. 200 ft.
250 ft. 150 ft.
150 ft. 100 ft.
125 ft. 75 ft.
100 ft.
65 ft.
Watts Required to Start Motor
Capacitor
600
600
850 1050
975 1350
1300 1800
1900 2600
2500 3300

GENERATOR CAPACITY

Make sure the generator can supply enough continuous (run-
ning) and surge (starting) watts for the items you will power
at the same time. Follow these simple steps.
1. Select the items you will power at the same time.
2. Total the continuous (running) watts of these items. This
is the amount of power the generator must produce to
keep the items running. See the wattage reference chart
at right.
3. Estimate how many surge (starting) watts you will need.
Surge wattage is the short burst of power needed to start
electric motor-driven tools or appliances such as a circu-
lar saw or refrigerator. Because not all motors start at the
same time, total surge watts can be estimated by adding
only the item(s) with the highest additional surge watts to
the total rated watts from step 2.
#14 Wire
375 ft.
200 ft.
125 ft.
100 ft.
65 ft.
Split Phase
850 1200
850 2050
2400
2700
3600
—
—
#16 Wire
250 ft.
125 ft.
100 ft.
50 ft.