Idiomas disponibles
Idiomas disponibles
(Original instructions)
A – Spray button
B – Steam blast button
C – Steam flow control
D – Auto-cleaning button
E – Temperature regulator
F – Pilot light
G – Filling spout
H – Spray nozzle
I – Soleplate
If the model of your appliance does not
have the accessories described above,
they can also be bought separately from
the Technical Assistance Service.
-
Fully extend the appliance's power cable
before each use.
-
Do not use the appliance if the
accessories or consumables attached to
it are defective. Replace them
immediately.
-
Do not use the appliance if the on/ off
switch does not work.
-
Do not use the appliance if any of the
switches do not work.
-
Use the appliance handle/s, to catch it or
move it.
-
Do not use the appliance if it is tipped up
and do not turn it over.
-
To keep the non-stick treatment in good
condition, do not use metal or pointed
utensils on it.
-
Respect the MAX level indicator. (Fig.1)
-
Disconnect the appliance from the mains
when not in use and before undertaking
any cleaning task.
-
Store this appliance out of reach of
children and/or persons with physical,
sensory or reduced mental or lack of
experience and knowledge.
-
Do not store or transport the appliance if
it is still hot.
-
Keeping the iron in its housing support
at maximum temperature for too long,
may cause its colour change, which will
not affect the correct working order of
the appliance.
-
For a correct operation, keep the
soleplate in proper conditions; do not
operate over metal objects (ironing
board metal parts, buttons, zips etc.)
-
It is advisable to use distilled water,
especially if the water in your area
contains clay or if it is "hard" (containing
lime or magnesium).
-
Check that the lid is closed properly
before starting the appliance.
-
Never leave the appliance connected
and unattended if is not in use. This
saves energy and prolongs the life of the
appliance.
-
Never rest the appliance into a surface
while in use.
-
Do not use the appliance on any part of
the body of a person or animal.
-
Do not use the appliance to dry textiles
of any kind.
-
Turn the thermostat control to the
minimum (MIN) setting. This does not
mean that the iron is switched off
permanently.
-
Make sure that all products' packaging
has been removed.
-
Some parts of the appliance have been
lightly greased. Consequently, the first
time the appliance is used a light smoke
may be detected. After a short time, this
smoke will disappear.
-
It is essential to have filled the deposit with
water to be able to work with steam.
-
Open water inlet lid.
-
Fill the deposit taking care to observe the
MAX level (Fig.1).
-
Close water inlet lid.
