Idiomas disponibles
Idiomas disponibles
Defect
The tool rotation is too
slow or does not start up.
The tool starts up and
then slows down
Insuffi cient power
After fi nishing work, the housing, ventilation openings, switches, auxiliary handle and covers should be
cleaned e.g. with an air jet (with a pressure not exceeding 0.3 MPa), paintbrush or dry cloth without the use of
chemicals and cleaning agents. Clean the tools and handles with a clean, dry cloth.
Used tools are recyclable materials - they cannot be thrown into household waste containers as they contain
substances dangerous to human health and the environment! Please actively help us in using the natural
resources responsibly and protecting the environment by handing over the used tool to a used tool storage
point. In order to reduce the amount of disposed waste, it is necessary to reuse or recycle it in another form.
The spare parts list is available on the manufacturer's website in the product data sheet.
Possible solution
Apply a small amount of WD-40 through the air inlet opening. Activate the tool for a few sec-
onds. The blades could stick to the rotor. Switch on the tool for approx. 30 seconds. Lubricate
the tool with a small amount of lubricant. Caution! Excessive amount of lubricant can cause the
tool to lose power. In this case, clean the drive.
The compressor does not provide an adequate supply of air. The tool is activated by the air
accumulated in the compressor tank. As the tank empties, the compressor does not keep up
with fi lling in the air shortages. Connect the device to a more effi cient compressor.
Make sure that the hoses have an internal diameter as specifi ed in the table in item 3. Check
the pressure setting to ensure that it is set to the maximum value. Make sure that the tool is
properly cleaned and lubricated. If there are no results, have the tool repaired.
M A N U A L O R I G I N A L
EN
17
