Idiomas disponibles
Idiomas disponibles
90550128 PCL180D
4/6/09
ADJUSTING TORQUE CONTROL - FIGURE F
This tool is fitted with a torque adjustment collar (3) to
select the operating mode and to set the torque for
tightening screws. Large screws and hard workpiece
materials require a higher torque setting than small
screws and soft workpiece materials.
•
For drilling in wood, metal and plastics, set the
collar to the drilling position symbol
•
For screwdriving, set the collar to the desired
setting. If you do not yet know the
appropriate setting, proceed as follows:
•
Set the collar to the lowest torque setting.
•
Tighten the first screw.
•
If the clutch ratchets before the desired result is achieved, increase the collar setting
and continue tightening the screw. Repeat until you reach the correct setting. Use this
setting for the remaining screws.
DUAL RANGE GEARING - FIGURE G
The dual range feature of your drill allows you to shift
gears for greater versatility. To select low speed, high
torque setting (position 1), turn tool off and permit to
stop. Slide gear shifter button (4) away from the
chuck. To select the high speed, low torque setting
(position 2), turn tool off and permit to stop. Slide gear
shifter button towards the chuck.
NOTE: Do not change gears when tool is running. If
you are having trouble changing gears, make sure
that the dual range gear button is either completely
pushed forward or completely pushed back.
KEYLESS CHUCK - FIGURE H
To insert a drill bit or other accessory:
1. Grasp the chuck (5) and rotate it in the
counterclockwise direction, as viewed from the
chuck end.
2. Insert the bit or other accessory fully into the
chuck, and tighten securely by rotating the
chuck in the clockwise direction as viewed from
the chuck end.
:
Do not attempt to tighten drill bits (or any other accessory) by gripping
the front part of the chuck and turning the tool on. Damage to the chuck and personal
injury may occur when changing accessories.
SCREW DRIVING
For driving fasteners, the reversing button should be pushed to the left. Use reverse
(button pushed to the right) for removing fasteners. When moving from forward to
reverse, or vice versa, always release the trigger switch first.
ON BOARD BIT STORAGE
A bit storage slot is built-in to the area just above the battery.
DRILLING
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the Safety Instructions.
• Use appropriate and required safety equipment, as instructed in the Safety Instructions.
11:00 AM
Page 10
10
F
3
G
4
H
5
