Idiomas disponibles
Idiomas disponibles
For models LWFR7100S, LWFR7200S, LWFR7600S, LWER5000S:
Nominal electrical characteristics:
For models: LWFR7300S, LWFR7400S, LWFR9000S:
Nominal electrical characteristics:
RANGE INSTALLATION
•
Keep these instructions for future reference.
•
Read the instructions for use before turning this appliance on.
•
Before installation, make sure that the local gas supply conditions (nature and LP gas
pressure) and the adjustment of the appliance are compatible.
•
Proper installation is your responsibility, which is why it is recommended that your range be
installed by a qualified or technical personnel of Whirlpool Service.
GENERAL RECOMMENDATIONS
•
It is the responsibility of the installer to comply with all the spaces specified in these
instructions.
•
Install your stove in a place protected from inclement weather and on a flat and resistant
surface to support its weight.
•
Do not install your stove on carpet or any flammable material.
•
If the floor is synthetic, verify that this material supports a temperature of at least 95° C
without deforming.
•
Do not allow children to use it or people who do not know how it works.
•
Keep the surroundings of the appliance free of combustible materials, gasoline and other
flammable vapors or liquids.Do not get too close to the flames of the burners, or wear
loose clothing, as it can ignite and cause burns.
•
Provide adequate maintenance.
•
Use the stove only for household use.
•
It is not a device for commercial use.
•
Use two or more people to move or install the stove.
•
If it is necessary to move your range, do not load or move it by pulling it from the handle,
open the oven door and take it from the top of the oven cavity, and move it.
Use two or more people to move and install product.
Failure to do so can result in back or other injury.
THIS PRODUCT SHOULD NOT BE INSTALLED IN BATHROOMS OR BEDROOMS
THE ADJUSTMENT CONDITIONS FOR THIS DEVICE ARE FOUND ON THE LABEL THIS ARTIFACT
MUST BE INSTALLED IN A KITCHEN OR ENVIRONMENTS THAT HAVE ADEQUATE VENTILATION
INSTALLATION
This appliance is not connected to a device for evacuating the products of combustion. It must
be installed and connected in accordance with the current installation requirements. Special
attention should be given to the relevant requirements on ventilation.
•
Remove all stickers and packing elements.
•
Identify and separate accessories from the stove.
•
Select the best location for your range, it should not be exposed to drafts and you should
have
•
enough space to open the oven door.
•
Do not install cabinets or kitchen furniture on top of the cooktop.
•
If you install extractor hood, place it at least 61 cm from the cooktop cover.
•
If your range has electrical accessories, place it near a wall outlet.
•
This gas range is equipped with a three-prong plug with ground contact for protection
against the risk
•
of electrocution. It must be plugged directly into a grounded wall outlet.
In some European factories the letter "W" of the part code mentioned herein will be automatically
17-Sep-2019 13:32:01 EDT | RELEASED
All manuals and user guides at all-guidesbox.com
105 - 140 V ~
105 - 140 V ~
WARNING
Excessive Weight Hazard
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
50/60 Hz
1,0 A Max.
50/60 Hz
15,0 A Max
32
