Motorola Nursery PIP12 TRAVEL Guia De Inicio Rapido página 6

1. Lift up the battery cover to remove it from the baby unit.
2. Insert the rechargeable Ni-MH battery cells supplied. Note the '+' and
'-' markings beside the battery compartment and insert in the correct
direction.
3. Place the battery cover back into place.
Connect the baby unit
1. Plug the DC plug of the power adapter into the DC jack on the side of the
baby unit and plug the other end of the AC adapter into the AC power outlet.
2. Switch on the AC power (if your AC power outlet has a switch). The battery
charging LED indicator lights up in red and turns dim until the batteries are
fully charged when the baby unit is not powered ON.
Note
The battery charging LED indicator is OFF when turning on the power button.
When disconnected from the power adapter, if it flashes red, it means the
battery level is low and needs recharging.
4.2 Parent unit
Install batteries
1. Lift up the battery cover to remove it from the parent unit.
2. Insert the rechargeable Ni-MH battery cells supplied. Note the '+' and
'-' markings inside the battery compartment and insert in the correct
direction.
3. Place the battery cover back into place.
6