Federal Signal Global G-STR Instrucciones De Instalación Y Mantenimiento página 5

All manuals and user guides at all-guides.com
Safety Messages to Installers and Users
It is important to follow all instructions shipped with this product.
This beacon is to be installed by a trained electrician who is
thoroughly familiar with and will follow all applicable national and
local codes in the country of use.
This beacon should be considered a part of the warning system and
not the entire warning system.
The selection of the mounting location for the beacon, its controls and
the routing of the wiring are to be accomplished under the direction
of the facilities engineer and the safety engineer. In addition, listed
below are some other important safety instructions and precautions
you should follow:
• Read and understand all instructions before installing or operating
this equipment.
• To avoid electrical shock hazards, do not connect wires when
power is applied. Failure to observe this warning may lead to
serious injury or death.
• Never alter the unit in any manner. Safety in hazardous locations
may be endangered if additional openings or other alterations are
made in units specifically designed for use in these locations.
• Do not connect this beacon to the system when power is on.
• After installation, ensure that all threaded joints are properly
tightened.
• Keep the unit tightly closed when in operation.
• After installation, test the beacon system to ensure that it is
operating properly.
• After testing is complete, provide a copy of this instruction sheet
to all personnel.
• Establish a procedure to routinely check the beacon system for
proper activation and operation.
Model G-STR Global Series Strobe Beacon
Installation and Maintenance Instructions
5