Lionelo Bastiaan i-Size Manual De Usuario página 14

right motion toward the backrest to make sure it is pressed as tightly as possible
against the car's bench seat.
6.
The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
NOTE! Any change in the tilt of the backrest during use of the seat requires readjustment
of the length of the Top Tether belt.
7.
Unbuckle the Top Tether belt, and then slide the buckle and hook (18, fig. B) to the
end of the unbuckled belt (fig. 5).
8.
Guide the belt through the Top Tether belt guide, located at the top of the seat
backrest (fig. 6).
9.
Attach the Top Tether belt to the anchor points in the car. Anchor points can be in
different locations depending on the vehicle (fig. 7b).
10. Tighten the Top Tether belt and make sure the indicator is green (fig. 8). The seat is
now properly installed in the car.
11. Place the child in the seat and adjust the headrest (see: Headrest adjustment).
12. Fasten the seat belts (see: Fastening and unfastening the child in the seat).
FORWARD FACING (100 – 150 CM)
1.
Remove the seat belts (see: Removal of seat belts).
2.
Press the seat rotation button (13, fig. B), then move the seat to the forward-facing
position (fig. 1). Try to move the seat, properly anchored will not allow you to change
position.
3.
Place the seat on the car's bench seat in the space provided for installation.
4.
Set the seat tilt to one of the 4 available positions (see: Seat tilt adjustment).
Note! If installing without ISOFIX, skip steps 5 to 7.
5.
Push in the ISOFIX sliding lever and extend the ISOFIX arms (fig. 2). Anchor the ISOFIX
arms to the attachments located in the car's bench seat. The arms will interlock and
you will hear a characteristic click (fig. 3). If necessary, use the plastic guides included
in the set to make installation easier (fig. 4).
6.
Press the seat against the backrest of the car's bench seat. Push the base using a left-
right motion toward the backrest to make sure it is pressed as tightly as possible
against the car's bench seat.
7.
The green indicator on the ISOFIX button must be visible on both sides (fig. 3).
8.
Place the child in the seat and adjust the headrest (see: Headrest adjustment).
9.
Pull out the seat belt (fig. 9)
10. Guide the shoulder belt through the shoulder belt guide (2, fig. B), which is located
EN ‑ 14 ‑