Idiomas disponibles
Idiomas disponibles
Cleaning & Maintenance
Troubleshooting
Whenever there is a problem with the appliance, check if you can solve it by following the tables below.
If the problem persists, contact customer service.
DESCRIPTION
Does not start
Hot or smells burnt
Clothes too dry
Clothes shrink
Lint forms on clothes
Note
If you cannot solve the problems yourself and need help:
- Press the button (On / Off).
- Disconnect the mains plug from the mains and call for service.
CAUSE
Power failure.
The plug is not properly con-
nected.
The temperature of the laundry
is too high.
The temperature fuse is discon-
nected.
The lint filter is dirty.
The suction or exhaust duct is
dirty.
There is too much laundry in the
dryer.
Laundry is not taken out in time
when finished.
Laundry is not sorted correctly.
Temperature is too high.
Too dry
It is correct that synthetic fibres
and permanent press fibre
cause hairballs. This is because
the correct rubbing causes the
formation of fluff.
Wait until the power is on.
Check the socket, make sure that the plug is
properly connected.
The laundry in the dryer must be after spin-
ning, and the laundry to be dried must not
exceed 3 kg.
Call the service technician to reset the tem-
perature fuse.
Make sure to clean the lint filter well in ad-
vance.
Clean the tube.
Make sure there is no overload of laundry.
Take the laundry out immediately when
finished.
Respect the maintenance label on the laun-
dry.
Observe the care label on the laundry. If clo-
thes shrink easily, examine them when they
are dry. Remove clothes when they are too
wet or too dry and hang them up until they
are completely dry.
Use fabric softener to lubricate the fibre,
when ironing clothes, apply a little fabric sof-
tener to the cuffs and neckline, turn the iron
outwards to reduce rubbing.
36
SOLUTION
English
infiniton.es
