Idiomas disponibles
Idiomas disponibles
EN
Figure 5 Detergent application
Units with Detergent Applicator Included
Follow manufacturer's label directions for mixing correct concentrations of detergent to water ratio
through the pressure washer is approximately 5.4% (1 to 19).
1. Unscrew to top of detergent applicator and fill applicator with detergent.
2. Replace top on applicator.
3. Remove lance from gun.
4. Attach detergent applicator to gun. ( See Figure 6)
5. Apply detergent so it thoroughly covers cleaning surface. Apply from bottom to top to prevent
detergent from sliding down and streaking.
6. Allow detergent to remain on the surface for a few minutes. This is a good time to use a brush to
lightly scrub heavily soiled areas.
Never allow detergent to dry on the cleaning surface.
7. Remove detergent applicator from gun and replace with the lance, or remove applicator from end
of lance.
8. Rinse detergent from surface.
NOTE: Flush detergent applicator with clear water following each use.
4. Final Rinse
Start final rinse at bottom an work upward. Make sure you thoroughly rinse the surface and that all
detergent has been removed.
5. Shut down
1. Be sure all detergent is flushed from system.
2. Turn off motor.
3. Turn off water supply.
11
