Idiomas disponibles
Idiomas disponibles
CAUTION: Since a turbo nozzle uses a narrow high impact stream, only use it in applications where
the cleaning surface cannot be damaged by narrow high impact spray. Additionally, the turbo nozzle
is NOT adjustable and cannot be used to apply detergent.
DETERGENTS
The use of detergents can dramatically reduce cleaning time and assist in the removal of difficult
stains. Some detergents have been customized for pressure washer use on specific cleaning tasks.
These detergents are approximately as thick as water. The use of thicker detergents, such as dish
soap, will clog the chemical injection system and prevent the application of the
detergent.
The cleaning power of detergents comes from applying them to a surface and giving the chemicals
time to break down the dirt and grime. Detergents work best when applied at low pressure.
The combination of chemical action and high pressure rinsing is very effective. On vertical surfaces,
apply the detergent starting at the bottom and work your way upward. This will prevent the deter-
gent from sliding down and causing streaks. High pressure rinsing should also progress from
the bottom to top. On particularly tough stains, it may be necessary to use a brush in combination
with detergents and high pressure rinsing.
Operation
The following cleaning procedure will help you to organize your cleaning task, and ensure that you
achieve the most beneficial results in the shortest amount of time.
Remember to use the spraying/cleaning techniques previously listed.
1. Surface preparation
Before starting a pressure wash cleaning job, it is important to prepare the surface that is to be
cleaned. This is done by cleaning the area of furniture, and making sure that all windows and doors
are closed tight. In addition, you should make sure that all plants and trees adjacent to the cleaning
area are protected by a drop cloth. This will ensure that your plants won't be sprayed by the deter-
gents.
2. Initial High Pressure Rinse
The next step is to spray the cleaning surface with water to clear off any dirt or grime that may have
collected on the surface. This will allow your detergent to attack the deep down dirt that has worked
its way into the cleaning surface. Before triggering the gun, adjust the nozzle to a wide fan pattern
and slowly adjust to the desired spray pattern. This will help you avoid applying too much concen-
trated spray to the surface which could cause damage.
3. Detergent Application
USE THE INSTRUCTIONS APPROPRIATE FOR MODEL PURCHASED
NOTE: Use only detergents formulated for pressure washes.
NOTE: Test detergent in an inconspicuous area before use.
10
