Idiomas disponibles
Idiomas disponibles
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to
disconnect the appliance from the electricity supply:
It is not sufficient to set the temperature adjustment
knobs on
(appliance off) to eliminate all electrical
contact.
Cleaning the appliance
• The external and internal parts, as well as the
rubber seals may be cleaned using a sponge that
has been soaked in lukewarm water and
bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in
warm water and soap or dishwashing liquid. Rinse
and dry them carefully.
• The back of the appliance may collect dust which
can be removed by delicately using the hose of a
vacuum cleaner set on medium power. The
appliance must be switched off and the plug must
be pulled out before cleaning the appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic
materials which are odour free. In order to maintain
an odour free refrigerator and to prevent the
formation of stains, food must always be covered or
sealed properly.
• If you want to switch the appliance off for an
extended period of time, clean the inside and leave
the doors open.
Defrosting the appliance
! Follow the instructions below.
Do not use objects with sharp or pointed edges to
defrost the appliance as these may damage the
refrigeration circuit beyond repair.
Defrosting the refrigerator compartment
necessary to clean the discharge hole regularly so
that the water can flow out easily.
All manuals and user guides at all-guides.com
The refrigerator has an
automatic defrosting
function: water is
ducted to the back of
the appliance by a
special discharge
outlet ( see diagram )
where the heat
produced by the
compressor causes it
to evaporate. It is
Defrosting the freezer compartment
If the frost layer is greater than 5 mm, it is
necessary to defrost manually:
1. Set the TEMPERATURE ADJUSTMENT knob to the
position
.
2. Wrap frozen foods in newspaper and place them
in another freezer or in a cool place.
3. Leave the door open until the frost has melted
completely. This can be made easier by placing
containers with lukewarm water in the freezer
compartment.
4. Clean and dry the freezer compartment carefully
before switching the appliance on again.
5. Wait for approximately 2 hours, i.e. until the ideal
storage conditions have been restored, before
placing food in the freezer compartment.
as indicated in the diagram.
Replace it with a similar light bulb within the power
range indicated on the cover (15W or 25W).
TEMPERATURE* Indicator light: to identify the
coldest area in the refrigerator.
1. Check that OK appears clearly on the indicator
light ( see diagram ).
2. If the word "OK" does not appear it means that
the temperature is too high: adjust the
REFRIGERATOR OPERATION knob to a higher
(colder) position and wait approximately 10 hours
until the temperature has stabilised.
3. Check the indicator light again: if necessary,
readjust it following the initial process. If large
quantities of food have been added or if the
refrigerator door has been opened frequently, it is
normal for the indicator not to show OK. Wait at
least 10 hours before adjusting the
REFRIGERATOR OPERATION knob to a higher
setting.
Replacing the light
bulb
To replace the light
bulb in the refrigerator
compartment, pull out
the plug from the
electrical socket. Follow
the instructions below.
Access the light bulb
by removing the cover
13
GB
