Idiomas disponibles
Idiomas disponibles
Scope of delivery
Pan
Glass lid
Thermostat
Knob
Collar
1 large screw with washer
2 heat shields
4 small screws
Before Initial Use
1. Remove the appliance from its packaging.
2. Remove all the packaging material such as foils, filling
materials, cable ties and cardboard packaging.
3. Check that all parts are present.
4. In the event that the package contents are incomplete or if
there is obvious damage, do not use the appliance. Return
it to the dealer immediately.
5. Operate the appliance without the lid for approximately
5 min on the highest setting (see "Initial Operation").
NOTE:
Any smoke or smells produced during this procedure are
normal. Please ensure sufficient ventilation.
6. We recommend that you clean the lid and the pan as
described under "Cleaning".
Assembly
1. Mount the knob on the glass lid:
•
To do this, place the knob and the ring collar on a flat
surface.
•
Place the lid on it upside down.
•
First push the silicone ring into the lid opening.
•
Insert the screw with the washer from the inside
through the lid and tighten the knob by hand.
2. Mount the heat shields on to the
handles:
•
Under each of the handles
you can see two drill holes.
•
Hold one heat shield in each
case between the pan and
handle.
•
Insert the screws into the drill holes and screw the heat
shields into place.
Initial Operation
Place the device on a heat-resistant surface.
1. Please ensure that the temperature regulator is turned to
0 (Off) and insert it into the socket of the thermostat.
The power socket is on the side of the device.
34
CAUTION:
If the thermostat is not
inserted correctly, this may
lead to abnormal heating, of
which the consequence may
be damage or accidents. You
should therefore ensure that
the thermostat is inserted
correctly.
2. Connect the device to a properly installed power socket.
3. et the temperature control according to what you intend to
do:
Temperature adjust-
Adjustment
ment in °C approx.
1
2
over 100°C
3 - 4
150° - 200°C
5
240°C
NOTE:
The device has reached the correct temperature when the
control lamp on the thermostat goes off. During operation
the control lamp goes on from time to time to show that the
correct temperature is being maintained.
Using the unit
•
The Party Pan should be preheated for approximately five
minutes. When the control lamp goes off, the pan is ready
for operation.
•
The cooking time depends on the type and quantity of
food that is to be cooked as well as the degree of cooking.
Please base these times on your own experience.
•
When turning the food that is being cooked, please use
wooden or Teflon utensils so as not to damage the non-
stick layer.
•
When cooking is finished the food may be kept warm by
turning the controls to 1.
WARNING:
•
The Party Pan is hot during use!
•
Hot steam is emitted from the lid.
Use
Keeping warm
Fried food,
hamburgers
Pancakes, scrambled
eggs, ham, bacon
Roasting
