Idiomas disponibles
Idiomas disponibles
Troubleshooting
Before you contact an authorized specialist
Problem
Possible cause / Action
Unit doesn't
∙ Check the power supply. ∙ Is the
start
unit turned on and the door securely
closed? ∙ Is a program selected?
∙ Is the water supply properly con-
nected and the water supply
opened?
Water is not
∙ Check the drain hose. ∙ Are the
drained off
filters or the kitchen sink clogged?
Noise
∙ Make sure that all dishes are se-
cured in the dishwasher. ∙ Place the
parts so that the spray arms can
rotate freely.
Foaming
Use only special dishwasher deter-
gent to avoid foaming. If this occurs,
open the door and let suds evapo-
rate. Add a bit of cold water to the
tub. Start a short rinse cycle to drain
out the water.
Flat table-
∙ Select a stronger program.
ware is not
∙ Make sure that the spray arms are
clean
not blocked by large dishes.
Spots and
∙ Extremely hard water ∙ low inlet
filming
temperature ∙ overloading the bas-
kets, improper loading ∙ old or
damp detergent ∙ incorrect dosage
of detergent
Cloudiness
Use less detergent if you have soft
glassware
water and select a shortest cycle to
rinse and clean glassware.
Black or
Aluminum utensils have rubbed
grey marks
against dishware. Use a mild abra-
sive cleaner to eliminate those
marks.
Stains on
Only use detergents without color-
inner sur-
ants.
face
Problem
Possible cause / Action
White film
Hard water minerals: clean the
on inside
interior by using a damp sponge
surface
with dishwasher detergent. Wear
rubber gloves.
Unsatisfac-
∙ Improper loading ∙ dishes are
tory drying
removed too soon ∙ wrong program
result
has been selected ∙ use of cutlery
with a low-quality coating
Error codes
For some malfunctions, flashing control lamps will
show the following error codes to warn you:
Code
Meaning / possible cause
Water inlet fault! Faucet not open, inlet
E1
blocked or water pressure too low.
E3
Malfunction of heating element.
Overflow / water leakage!
E4
Communication error / display malfunc-
Ed
tion!
CAUTION:
If overflow occurs, turn off the main water sup-
ply before calling an authorized technician.
If there is water in the lower housing part due to
an overfilling or a small leak, remove this water
before restarting the appliance.
NOTE:
If a problem persists after following the steps
above, please contact your distributor or an au-
thorized technician.
Electrical connection / Water supply....................
Connection voltage: ...............220-240 V~ / 50 Hz
Connection power: .........................730 – 860 W
Water pressure: .............................0.04 – 1 Mpa
Dimension H x W x D / Weight...........................
Unit size: ..........................43.5 x 42.0 x 43.5 cm
Net weight: .......................................ca. 13.5 kg
78
Technical Data
