Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WHEELS (FIG. D, D-1)
NOTE: Verify that the front side of the wheel with three
ribs is facing out. (Fig. D)
Fig. D
FRONT
1. Hardware Bag "R"- Attach one wheel (1) to the
outer side of the right stand leg (2) using the hex
bolt (3), two flat washers (4), sleeve (5) and the
nut (6), as shown in Fig. D-1.
NOTE: The sleeve (5) goes inside the opening in
the wheel.
2. Tighten the nut and bolt using two 17 mm or
adjustable wrenches.
NOTE: Do not overtighten or the wheel will not turn.
3. Spin the wheel to make sure it moves properly.
4. Repeat the above steps for the other wheel.
Fig. D-1
6
NOTE: If you plan to use the anchor plates to
attached the stand to the ground, please see section
on page 12.
INSTALLING THE STAND LEG TUBES (FIG. E)
With assistance, turn the stand so that the stand bed is
facing up.
1. Hardware Bag "M"- Insert one stand leg tube (1)
into the stand (2). Align the two holes of the stand
leg tube (1) with the holes on the stand.
2. Insert bolt (3) though a curved washer (4), onto one
of the holes (5) on the stand and then though
another curved washer (4). Then, tighten the
bolt (3) with lock nut (6) using two 13 mm or
adjustable wrenches.
NOTE: There are two mounting holes for securing
the leg tube to the stand on each side. One is from
the vertical direction; the other one is the horizontal
direction.
3. Repeat steps 1-2 for the other leg tube.
BACK
3
4
5
4
2
1
– 9 –
Fig. E
1
INSTALLING THE STAND HANDLE TUBES (FIG. F)
With assistance, raise the stand up so that it is
standing upright.
1. Hardware Bag "L"- Attach one stand handle (1) to
one side of the stand using two screws (2) and two
nuts (3). Tighten with a phillips screwdriver and a
10 mm or adjustable wrench. Repeat this step for
assembling the other stand handle tube.
NOTE: Both stand handles are the same. There are
two mounting holes for securing each handle tube to
the stand. One is from the vertical direction; the other
one is the horizontal direction.
Fig. F
WARNING
Be sure to perform a folding test at this stage by
following the instruction in section "FOLDING THE
STAND" on page 15. If the stand can not be fully
folded and locked, please check if the bumpers are
installed properly and retighten screws and nuts for the
bumpers again. If the stand cannot be locked after the
adjustment, the stand must be serviced before use.
English
3
6
4
5
3
4
6
2
1
2
3
2
3
Tabla de contenido
