Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
TRANSPORTATION AND STORAGE (FIG. T, U)
For transportation and storage usage, follow the
instruction in section "FOLDING THE STAND" on page
15. Be sure to hear a click when the stand is folded up
and hold the stand handles with both hands securely.
The stand should be in its upright position as shown in
Fig. T. To be ready for storage or transportation, please
refer to Fig. U for proper transporting position.
● Do not transport the unfolded stand with a miter saw
mounted on it.
● Before transporting or storing the stand, you MUST
remove the miter saw from the stand.
● When carrying the stand in a vehicle, securely tie it
down to prevent movement and possible damage.
● When storing the stand, never lean the stand against
wall.
● If any part of the stand is not operating properly,
stop using the stand and have it serviced by a
metabo HPT authorized service center.
● When servicing the stand, use only identical
metabo HPT replacement parts. Use any other parts
may cause hazards or product damage.
● Repairs should be conducted only by a metabo HPT
authorized service center.
● Always wear safety goggles or safety glasses
with side shields and dust mask during miter saw
operation or when blowing dust.
● Occasionally check the saw mounting brackets,
making sure the mounting brackets are tight by
following "ADJUSTING THE SAW MOUNTING
BRACKETS" on page 13.
WARNING
MAINTENANCE
WARNING
Fig. U
GENERAL MAINTENANCE
Remove the miter saw when servicing or cleaning the
stand. Use clean cloths to remove dirt, dust, oil, grease
etc. Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by
their use.
Do not use the brake fluids, gasoline, petroleum-based
products, penetrating oils and so on to contact with
plastic parts. Chemical can damage, weaken or destroy
plastic which may cause serious personal injury.
– 16 –
WARNING
Tabla de contenido
