Idiomas disponibles
Idiomas disponibles
GB
IRL
Fault
Liquid flows out of the
pump
Piston pressure gauge
does not indicate any
pressure.
Safety valve blows off too
early.
The nozzle does not
spray even though
pressure is present
The shut-off valve does
not close.
Liquid emerges without
the lever being activated.
Contact address for additional information → Title page.
Warranty
We guarantee that from the time it is first purchased for a period of the legally valid required
warranty period (maximum 3 years) this device will not exhibit any material or processing
errors. If defects are discovered during the warranty period, MESTO or the distributor in
your country will repair the device without charging for the labor or material or (at the
discretion of MESTO) replace the device itself or its defective parts.
If such defects are discovered, please contact us immediately.
We require the invoice or cash register receipt for purchase of the device.
The warranty does not include wearing parts (seals, O-rings, diaphragm, etc.) or defects,
which have occurred due to improper use or unforeseeable circumstances.
CE Declaration of Conformity
In accordance with EC Directive 2006/42/EC, Annex II, No. 1A.
We, MESTO Spritzenfabrik Ernst Stockburger GmbH,
Ludwigsburger Straße 71, D-71691 Freiberg
declare under our sole responsibility that the pressure spraying devices of the series 3275
and 3270, as supplied from factory number AE2 meet all the relevant requirements of
Directive 2006/42/EC of the EU.
Furthermore the devices correspond to Directive 97/23/EC for Pressure Equipment.
Rolf Rehkugler is authorized to compile the technical documentation.
Freiberg, 01/01/2014
Bernd Stockburger
- Managing Director –
AUS
USA
Cause
Valve disc [17] dirty or
defective. (Fig. 18)
Piston pressure gauge [8] is
defective. (Fig. 19)
Nozzle [18] (Fig. 20) or / and
filter [20] (Fig. 21) is clogged.
O-ring [26] of the pressure bolt
[27] not greased / lubricated.
(Fig. 23)
Pressure bolt [27] or
O-ring [26] defective. (Fig. 23)
NZ
Remedy
Clean or replace the valve disc.
Replace the piston pressure
gauge.
Clean the filter or / and nozzle.
Grease the O-ring [26]
(dismantle shut-off valve
→ section "Care and
maintenance")
Replace the pressure bolt or
O-ring.
17
CDN
IND
