Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for impact drilling
in brick, concrete and stone as well as for
drilling in wood, metal and plastic.
1. AUXILIARY HANDLE (See A)
Slide the handle
onto the drill
and rotate to the
desired working
position. To clamp
the auxiliary
handle rotates
the handgrip
clockwise. To loosen the auxiliary handle rotates
the handgrip anti-clockwise. Always use the
auxiliary handle.
2. INSTALLING THE DEPTH GAUGE (See B)
The depth gauge can be used to set a constant
depth to drill. To
use the depth
gauge, loosen the
handle by rotating
the bottom section
of handle anti-
clockwise. Insert
B
the depth gauge
through hole in handle. Slide the depth gauge to
required depth and tighten fully.
3. CHUCK ADJUSTMENT (see C)
WARNING: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.
To open the chuck jaws rotate the front section
of the chuck while holding the rear section. Insert
the drill bit between the chuck jaws and rotate
the front section
in the opposite
direction while
holding the rear
section. Ensure
that the drill bit is
C
in the center of
the chuck jaws.
Finally, firmly rotate the two separate chuck
sections in opposite directions. Your drill bit is
A
now locked in the chuck.
4. ON/OFF SWITCH
Depress the switch to start the tool and release it
to stop your tool.
5. LOCK-ON SWITCH (see D)
Depress on/off
switch then lock-
on button, release
on/off switch
first and lock-on
button second.
Your switch is
D
now locked on
for continuous use. To switch off your tool just
depress and release the on/off switch.
6. VARIABLE SPEED CONTROL (See E)
Adjust the variable
speed control
to increase or
decrease the
speed according
to the material
and accessory
E E
to be used (also
possible during no load operation). Low speed
will provide low torque and high speed gives
higher torque.
7. FORWARD AND REVERSE ROTATION
CONTROL (see F)
For drilling use forward rotation marked "
(lever is moved to the left). Only use reverse
rotation marked
"
" (lever
is moved to the
right) to release a
jammed drill bit.
NOTE: Never
move the
F
forward/reverse
switch whilst the drill in operation or the on/
off switch is locked as this will damage the
drill.
8. HAMMER
OR DRILLING
CONTROL (see
G)
When drilling
masonry and
concrete choose
G
1
2
"
31
