Idiomas disponibles
Idiomas disponibles
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
WHEN USING THE STANDARD BALL/DOWN-
ROD MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the locking slots of the ceiling canopy
with the two screws in the mounting bracket.
Push up to engage the slots and turn clock-
wise to lock in place. Immediately tighten
the two mounting screws firmly.
2. Install
the
remaining
screws into the holes in the canopy and
tighten firmly.
3. You may now proceed to attaching the
fan blades.
CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mount-
ing bracket and align the locking slots of the
ceiling canopy with the two screws in the
mounting bracket. Push up to engage the
slots and turn clockwise to lock in place.
Immediately tighten the two mounting
screws firmly.
8.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. You may now proceed to attaching the fan
blades.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE EN-
GAGED AND FIRMLY TIGHTENED.
Attaching the
Fan Blades
NOTE: Your fan blades are reversible. Select
the blade side finish that best accentuates your
decor.
two
mounting
1. Attach blade to blade bracket using the
screws provided as shown in Figure 13.
Please note that the rubber washers are pre-
attached to the blade bracket. Insert a screw
into the bracket. Repeat for the two remain-
ing screws.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot
on the bottom of the motor and tightening
the motor screws. Please note that the mo-
tor screws are pre-attached into the blade
bracket (Figure 14).
4. Repeat steps 1-3 for the remaining blades.
PLEASE REMOVE RUBBER MOTOR STOPS ON
THE BOTTOM OF THEFAN BEFORE INSTALL-
ING BLADES OR TESTING MOTOR.
Mounting screw
Blade
Pre-attached
rubber pad
Blade
bracket
Figure 13
Figure 14
