Idiomas disponibles
Idiomas disponibles
Procedure:
Step 1: Unscrew the fixation screws X, Y of the lamp system and carefully remove it from the housing.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder.
Step 3: Insert the lamp into the lamp holder.
Step 4: Replace the lamp system in the housing and tighten the fixation screws.
Step 5: Adjust the lamp as described under lamp adjustment.
Lamp adjustment
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "A, B, C" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.
Overhead rigging
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
Do not operate this device with opened cover!
The lampholder is aligned at the factory. Due to differences
between lamps, fine adjustment may improve light
performance.
Strike the lamp, open the shutter and the iris, set the
dimmer intensity onto 100 % and focus the light on a flat
surface (wall). Center the hot-spot (the brightest part of the
beam) using the 3 adjustment screws "A, B, C". Turn one
screw at a time to drag the hot-spot diagonally across the
projected image. If you cannot detect a hot-spot, adjust the
lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three
screws "A, B, C" clockwise ¼-turn at a time until the light
is evenly distributed.
23/57
00031630.DOC, Version 1.0
