Idiomas disponibles
Idiomas disponibles
PORTABILITY KIT PART NUMBER: 0070922
TOOLS REQUIRED: 10x13 mm wrench and 5 mm hex key (provided in tool kit), block(s) of wood (minimum of 6" tall).
Refer to the parts list on page 47.
WHEEL INSTALLATION
1. Block up the alternator end of generator to install wheel kit.
2. Slide the wheel (item 39) and spacer (item 38) onto the axle (item 40).
3. Slide axle through the axle tube on the carrier, with the offset side of the wheel hub against the axle tube.
4. Secure the wheel to the axle with the M12 washer (item 37) and pin (item 36).
5. Repeat above instructions for the remaining wheel.
FOOT INSTALLATION
1. Blocking up the engine side of the generator, assemble the foot spacer (item 21) and foot (item 20) to the carrier (align
with holes in tubing) with an M8 washer (item 19) and M8 x 80 bolt (item 18). Thread an M8 nyloc nut (item 22) to the
bolt to secure the assembly.
2. Repeat above instructions for the remaining foot.
HANDLE INSTALLATION
1. Slide M8 x 50 bolt (item 26) through handle bracket and handle (item 23 and 24 or 25) as shown in diagram and
secure with M8 nut (item 22). Tighten until handle is securely clamped to the carrier.
2. To extend the handle, press the handle release button. Pull the handle up until the handle release button locks in place.
3. Repeat above instructions for the remaining handle.
English
PORTABILITY KIT INSTALLATION
PORTABILITY KIT INSTALLATION
8
Customer Hotline 1-800-445-1805
