Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS POUR L'ASSEMBLAGE
NOM DES PIÈCES
Nettoyeur haute pression
$VVHPEODJH GH OD JkFKHWWH
Lance de pulvérisation
Cuve à savon
Piédestal
Étui pour le pistolet
Embout turbo
Vert - Embout à petit angle (25°)
Blanc - Embout à large angle (40° )
Outil de nettoyage à pointe de pulvérisation
Vis
Manuel d'utilisation
Guide rapide de démarrage
FIGURE
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk
Set-up
Installing the wheels
Insert the axle through the wheel.
WARNING:
of injury or death, user must read and understand operator's manual before using this product.
1
Slide the washer over the axle pass the pin hole.
Connect garden hose to pressure
washer water intake.
over the axle and insert the pin through the hole to firmly fasten
Insert the axle and wheel through the frame. Slide the washer
the wheel assembly.
1800 PSI / 1.1 GPM
2
Assemble pressure washer gun to spray wand.
Wheel
ELECTRIC PRESSURE WASHER
GPW 1800
USING DETERGENT
Axle
Washer Pin
Install blue or black soap nozzle.
Put pressure washer detergent in detergent tank.
3
Connect desired pressure tip.
Squeeze trigger and wait approx.1 minute for soap.
Installing the gun holder
Line up the screw sleeves with the holes in the upper handle
and push through.
4
screwdriver (not included) until the screw is tight.
Insert the screw and turn clockwise with a Phillips head
handle.
Insert high pressure hose into trigger
SPRAY TIP
SPRAY TIP APPLICATION
Red - Stream tip (0° )
5
Connect the high pressure hose to the
O
0
amount of pressure. It is best used for removing hard, stuck-on grime or dirt.
The red 0 degree tip provides a straight line of spray. It provides the highest
water outlet connector.
Green - Narrow fan tip (25° )
The green pressure washer tip provides high versatility with its 25 degree angle tip.
25
O
dirt from surfaces, but is designed to not damage many surfaces. This pressure
Referred to as the washing tip, because it provides adequate pressure to remove
6
Turn on water at outlet.
washer tip is designed for "sweeping" foliage or debris given its wide angle. This tip
is versatile due to its wide area of cleaning and strong pressure application.
Installing the upper handle
White - Wide fan tip (40° )
The white 40 degree tip, referred to as the "fan" tip creates the widest area of
7
handle assembly (1) as you slide the handle onto the frame (2).
Push and hold the push-pin buttons on the sides of the upper
40
O
or delicate cleaning applications. It is recommended for light cleaning on wood
cleaning with relatively low pressure. This pressure washer tip is best used for light
Run water hose for 30 seconds with the
motor in OFF position. This helps drain air
(1)
decks and other soft or delicate surfaces.
S
30
from the tank and lines.
Black - Soap spray tip
8
Connect power cord to wall outlet
Push-pin
(2)
SOAP
pressure high volume for optimum performance. Soap cannot be applied under
The black soap spray tip, is used for soap application. Soap is applied under low
Extension cord not recommended.
high pressure with this machine.
Turbo Nozzle Tip
9
Turn on Pressure Washer
The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to
break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches
IMPORTANT: Ensure water outlet is On
before turning power On to avoid damage
wide, depending on a distance between the tip and the surface being cleaned.
to the pump.
NOTE:
Missing parts, accessories or need a service center?
Do Not Return to Store
with an Auto Start/Stop feature.
AUTO ON/OFF SWITCH: This Pressure washer is equipped
Call : 1-888-909-6757
Pump will pressurize and shut down immediately.
To operate: Turn the power switch to the On (I) position.
www.GreenWorksTools.com
Once the trigger of the gun is depressed the unit will turn on.
Rev:02
Unit will shut off and be in standby mode when trigger is
released.
10
QTÉ
1
1
1
1
1
1
1
1
1
1
4
1
1
Tabla de contenido
Solución de problemas
