Swiss Pro+ SP-STM10.1WB Manual De Usuario página 9

The steam mop uses tap water. However, in hard water areas,
distilled water should be used for better performance.
Make sure that the copper cone in the water tank is always
submerged in water when using the steam cleaner.
Fig. 2b
(As illustrated in Fig. 2b)
Notice:
Never put detergents or fragrances in the steam mop. This will make operation unsafe and
damage the device.
2. Turn the steam switch to adjust the size of the steam production. You can adjust the steam flow
control and steam output while using the steam mop.
3. Once the unit is fully assembled and filled with water, plug the power cord into a grounded outlet.
On/off switch (O/I) is in the OFF (O) position. Set the power switch (O/I) to the ON position (I).
After about 30 seconds, the steam control will turn on, you can then adjust the steam output, the mop
will start to release steam. To stop dispensing steam, turn off the steam control and then move the
power switch (O/I) to the OFF position (O) (as shown in Fig. 2c). Allow the device to reset by waiting 30
seconds before turning the device back on. If you turn on the device without waiting, it will cause
puddles. Puddles may also occur if you turn off the appliance and leave the steam control on.
Make sure that the appliance is completely switched
off and disconnected from the mains after each use.
4. Slowly move over the surface to be cleaned.
The absorbent mopping cloth absorbs the dirt
Fig. 2c
loosened by the steam. Apply the steam generously.
Keep a towel on the hand and wipe off any
excess water that may build up.
5. When the steam mop stops dispensing steam, simply turn off the appliance and remove the plug
from the socket. Refill the water tank and continue cleaning.
9