AFTER USE
1.
Remove the plug from the mains socket.
2.
Allow the mop pad/cloths to cool and carefully remove the cleaning cloth from the mop head as the
cleaning cloth may still be hot.
3.
Any remaining water in the water tank must be emptied before storing the appliance. Always empty
the water tank at the end of each use.
4.
Allow all water (which may remain as condensate product) to drain from the steam vent before
storing the appliance.
5.
Wrap the power cord around the upper and lower cord wrap.
6.
Wipe all surfaces of the steam mop with a soft cloth. Keep it in a protected, dry place.
7.
Please store the device in a cool and dry place when not in use. Do not leave it exposed to sunlight
or rain.
8.
Storing the steam mop upright with a wet mop/cloth may result in the formation of white spots on
your floor. To remove the white spots, clean the area with vinegar. Be sure to remove the mop/cloth
before storing.
CLEANING AND MAINTENANCE
WARNING
ENSURE THAT THE APPLIANCE IS DISCONNECTED FROM THE OUTLET WHILE CLEANING
AND MAINTENANCE OF IT.
Drain the remaining water in the tank and clean the tank after each use.
Use detergent to clean the accessories (straight nozzle and round brush) if they are dirty. Then wash it
with clean water and let it air dry.
How to descale the inside of the water tank:
To remove limescale from the water tank, add one or two tablespoons of white vinegar to a full water
tank, close the water tank cap and shake the contents.
Do not turn on the steamer. Leave the device for a few hours. Empty the water tank, refill it with clean
water and empty it until it rinses clear.
WARNING
DO NOT IMMERSE THE STEAM MOP IN WATER.
Cleaning procedure to remove lime scale :
If your steam cleaner starts producing steam more slowly than normal or stops producing steam, you
may need to remove the limescale. Limescale can build up on the metal parts over time and greatly
affect the performance of the mop. It is necessary to regularly remove limescale. Approximately after
using a full tank of water 25-50 times or at least once a month, especially in hard water areas. The
frequency of limescale removal depends on the hardness of your tap water and how often you use the
steam cleaner.
The steam mop uses tap water. However, in hard water areas, distilled water should be used for
better performance.
Follow these procedures to remove limescale from the steam cleaner:
By using the scraper:
Make sure that the steam mop is disconnected from the mains before performing maintenance.
By using cleaning solution:
Make a solution of 1/3 white vinegar and 2/3 tap water and add to the water tank.
Secure the appliance and position it so that the steam that is released is not directed at the floor or
12