Idiomas disponibles
Idiomas disponibles
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is suf-
ficient to inflict serious injury.
WARNING:
Keep water and mist discharge pointed away from all
electrical devices to reduce the risk of electrocution or
electric shock.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Always remove battery pack or unplug extension cord
from your product when you are assembling parts,
making adjustments, cleaning, or when not in use.
Removing battery pack or unplugging extension cord
will prevent accidental starting that could cause serious
personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
General ventilation of most household spaces
WARNING:
Hybrid tools are always in operating condition. Therefore,
switch should always be in the OFF ( 0 ) position when
not in use.
NOTICE:
This product is designed to be powered by either a
RYOBI
ONE+
18V battery pack (DC mode) or by elec-
™
™
tric power (AC mode). Either power source can be used
by installing an approved battery pack or power cord into
the product as described in this manual.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page 11.
Place the speed switch in the OFF ( 0 ) position.
Open the battery compartment door.
Insert the battery pack into the product as shown.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
Close the battery compartment door.
WARNING:
Do not use the misting fan unless the battery cover is
fully closed. NEVER allow water or any liquids to enter
the battery compartment.
Depress the latches to remove the battery pack.
NOTE: If desired, the battery cover can be locked by
installing a padlock through the holes at the top of the
cover.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
USING A POWER CORD (NOT INCLUDED)
See Figure 4, page 12.
NOTE: Use a GFCI rated cord.
Place the speed switch in the OFF ( 0 ) position.
Insert the female end of the power cord into the product
as shown.
Connect the male end of the power cord to the power
source.
Make sure the power cord is secured before beginning
operation.
FAN LOW/OFF/HIGH SWITCH
See Figure 5, page 12.
The LOW/OFF/HIGH fan switch is located on the center
front of the base.
To select LOW speed, press ( I ).
To select HIGH speed, press ( II ).
To turn the fan OFF, select the center position ( O ).
8 – English
