Idiomas disponibles
Idiomas disponibles
AUTODARKENING WELDING FILTER AND
PROTECTION SCREENS ASSEMBLY
/ Grand DS /
1. Slide in the inner protection screen on the inner side of the
autodarkening welding filter as shown in figure (1.).
2. From the external side of the helmet shell, insert the welding
filter in the filter opening. Begin by inserting the filter at the
bottom, so that it clicks in the bottom clip (2.a); then push in
the top part so that it clicks into the top clip (2.b).
3. Insert the external protection screen into its position with four
side holders. Hold the protection screen with your thumb and
middle finger and place it on the side of your thumb into the slots
of both side holders. The indent of the helmet shell provides
the necessary space for your thumb (3.a). With your middle
finger bend the protection screen and with the aid of the other
fingers place it in both side slots (3.b).
4. Close the helmet shell with the external frame. Insert the
bottom two pins in the lowest two openings of the helmet
shell and push the top part of the frame into the helmet shell
so that the two upper pins click in the pin openings on both
sides (2x click) (4.).
1.
2.a
2.b
3.b
2
1
3.a
4.
7
