Idiomas disponibles
Idiomas disponibles
PROTECTION SCREEN REPLACEMENT
1. Remove the external frame. From the internal side of the
helmet shell squeeze the two pins towards each other,
release the frame and slightly push it out (1.a), then rotate it
to release the bottom two pins (1.b).
2. Hold the protection screen with your thumb and middle
finger on the side extensions along the indents in the
helmet shell intended for your fingers. Press on the protec-
tion screen to slightly bend it and remove it from the holder
slots (2.).
3. Insert a new protection screen and close the cover as
described in the previous section, under points 3 and 4.
1
2
8
1
2
1.a
1.b
During assembly of the helmet and welding
filter, or during the replacement of the pro-
tection screens, make sure that all parts are
firmly in place thus preventing any light from
entering the helmet. Should there still be any
light entering, repeat the procedure until the
problem is eliminated, otherwise the helmet
must not be used for welding. Before placing
the new protection screens, always remove
the protection layers from both sides.
2.
