Idiomas disponibles
Idiomas disponibles
WH70 BH3
HELMET AND HARD HAT
®
ASSEMBLY / WH70 BH3
BH3
helmet with Safety cap concept /
®
If you have purchased the WH70 BH3
ing helmet in combination with hard hat, a
two part (left and right) hard hat adaptor will
be replacing the standard headgear. Each
of the two hard hat adaptor parts are clearly
marked with L (left) and R (right) on the main
body. Please choose the right one for each
side.
1. While pressing the screw with your index finger, loosen the
nut, as shown on figure 1.
2. Push the screw through rectangular opening in the helmet
shell, while still holding the screw. Put the pin for the tilt
adjustment in one of the three holes in the helmet shell.
Choose the right tilt adjustment hole for your maximum
comfort (2.).
3. Tighten the nut on the screw (3.).
4. Repeat the assembly of the hard hat adaptor on the op-
posite side of the helmet.
5. Insert the wedges of the hard hat adaptor into the hard hat
slots. Make sure that the lower latches of the hard hat adap-
tor have stuck over the edges of the hard hat (5.).
6. The headgear of the hard hat can be adjusted by turning
the rear wheel in order to fit any head size. Press the wheel
and hold it while turning, release the wheel when reaching
the position of maximum comfort, so that it will lock in the
required position (6.).
7. The two springs of the hard hat adaptor hold the helmet in
two extreme positions: up and down (7.).
The headgear is equipped with a replace-
able sweatband. Sweatbands are available
through your local dealer.
1.
4
HH - version of WH70
®
weld-
®
LEFT
RIGHT
2.
5.
7.
3.
6.
