Depth Stop Adjustment - Delta ShopMaster S26-261L Manual De Instrucciones

LASER VERTICAL ANGLE
ADJUSTMENT
If you notice the laser line does not remain parallel to the
blade as the saw head is lowered to make a cut refer to
Figure 24 and follow these instructions: using a Phillips
head screwdriver turn the screw (B) to adjust the vertical
angle of the laser.
LASER OFFSET ADJUSTMENT
If you notice the laser line is offset from the actual cut line
refer to Figure 25 and follow these instructions: using a
Phillips head screwdriver turn the screw (C) to adjust the
offset.

DEPTH STOP ADJUSTMENT

This miter saw is equipped with an adjustable depth stop
for making through cuts and non-through cuts.
Refer to Figure 26 and follow these instructions in
order to set the depth stop at a specific cut depth:
use a Phillips head screwdriver to loosen screw (E) and
then rotate the stop bracket (D) counterclockwise into
the down position. Make sure to re-tighten screw (E).
The cut depth can now be adjusted by turning the depth
adjustment screw (C).
Refer to figure 26 and follow these instructions
in order to make a through cut: use a Phillips head
screwdriver to loosen screw (E) and then rotate the stop
bracket (D) clockwise into the up position. Make sure to
re-tighten screw (E).
Always check to make sure screw (E) is
tightened before making a cut. Failure to
do so may result in injury.
ADJUSTMENTS
20
B
FIGURE 24
C
FIGURE 25
C
FIGURE 26
E
D