Erreka CICLON CL210 Manual Del Instalador página 55

Attach the arm to the operator
Slide arm
3
Option A: Operator with slide arm
Attach the arm to the door
Articulated arm
I247C1
1 Position the drag wheel (1), supplied with the arm,
in the operator shaft.
2 Install the arm (2) and the cap (3) using the
appropriate screw and washer. The installation
differs in line with the type of arm (slide or
articulated).
1 In CL210F (T2000VFI), CLS210F, CL250F, CLS250F
models, unlock the motor with the unlocking key,
see section "Manual operation" on page 42.
2 Close the door and mark the arm bearing position
on the door (A).
3 Open the door to the required point and mark the
arm bearing position on the door (B).
4 Attach the rail (1) to the door (2), aligned with
regards to the two marks made.

See the sliding arm instructions.
CICLÓN Electromechanical Operator
INSTALLATION
51