Idiomas disponibles
Idiomas disponibles
ISSUE
The milk frother
does not work.
The milk frother
has spilled.
The milk frother is
burning.
There is little foam.
The foamer does
not produce foam.
PROBLEM RESOLUTION
CAUSE
Wrong voltage.
The plug is not connected properly or
has no power.
The power base is not seated properly
or is not making good contact.
The internal temperature is too high
(dry-burn protection).
Continued use. You have changed
modes immediately after using
another mode.
There is dirt in the feed base or the
feed port on the skimmer base has
gotten wet, which could cause a poor
connection to the base.
The milk volume exceeds the maxi-
mum capacity of 160 ml.
The milk volume exceeds the maxi-
mum capacity of 350 ml.
The frother has been used repeatedly
without cleaning it.
There is little milk.
If the product heats up and the motor
speed is normal, this problem is main-
ly due to the milk (milk spoilage, etc.).
Wrong or damaged accessory.
The milk used is not whole milk.
SOLUTION
Connect it with the proper
voltage.
Check the plug and the electrical
installation.
Remove the skimmer and replace
it properly.
Add cold water to the frother to
cool it down.
Wait for it to cool down or replace
the milk before use.
Clean any dirt or make sure the
feed port on the skimmer base
is dry.
Use the milk frother with the milk
volume between the inner mini-
mum and maximum marks.
Use the milk frother with the milk
volume between the inner mini-
mum and maximum marks.
Always clean the frother after
each use.
Use the milk frother with the milk
volume between the inner mini-
mum and maximum marks.
It is recommended to replace
milk.
Use the proper accessory or
replace it with a new one.
Use whole milk with fat content >
3.0% for best results.
E N G L I SH
11
