Lea LE36255-60DR Manual De Instrucciones página 17

Cortadora de setos
Idiomas disponibles
  • ES

Idiomas disponibles

4) Apply  anti‐rust  oil  to  the  metal  parts  such  as  the  throttle  wire,  etc.,  put  the 
cover on the blade, and keep it indoors to avoid exposing it to dampness. 
 
STORAGE   
 So that the hedge trimmer will work again after a long period of inactivity, you 
should observe the following points:   
 Empty the petrol tank. To do this, start the engine and let it run until it reaches 
a  standstill.  Dispose  of  the  remaining  petrol  in  an  environmentally  friendly 
way.   
 Let the engine cool and take out the sparking plug.   
 Pour a small spoonful of 2‐stroke mixture into the sparking plug opening and 
slowly pull the starter cord right through to the end several times. This gets rid 
of small deposits of rust and lubricates the piston and cylinder.   
 Check  the  sparking  plug  and  replace  it  if  too  much  of  the  firing  tip  has  been 
burnt off.   
 Keep the blade in a dry place – out of the reach of fire.   
 
TROUBLE SHOOTING   
PROBLEM 
Unit won't start or 
starts but will not run.   
Unit starts, but engine 
has low power. 
Engine sputters. 
PROBABLE CAUSE 
• Incorrect starting procedures.   
• Incorrect carburettor mixture 
adjustment setting.   
• Fouled sparking plug.   
• Empty fuel tank.   
• Primer bulb was not pressed 
enough.   
• Fuel filter is plugged.   
• Incorrect lever position.   
• Dirty spark arrester screen.   
• Dirty air filter.   
• Incorrect carburettor mixture 
adjustment setting service 
dealer.   
• Incorrect carburettor mixture 
adjustment setting.   
• Air filter is plugged.   
• Old or improperly mixed fuel.   
GB
• Follow instructions in the User 
Manual.   
• Have carburettor adjusted by 
an Authorized Service Centre.   
• Clean/gap or replace plug.   
• Fill fuel tank with properly 
mixed fuel.   
• Press primer bulb fully and 
slowly 10 times.   
• Replace the fuel filter.   
• Move to RUN position.   
• Replace spark arrester screen.   
• Remove, clean and reinstall 
filter.   
• Have carburettor adjusted by 
an Authorized Service Centre.   
• Have carburettor adjusted by 
an Authorized Service Centre.   
• Replace or clean the air filter.   
• Drain gas tank/add fresh fuel 
mixture.   
15
CORRECTIVE ACTION 
loading