Import Nt S Fegu Rds - Windmere I-335 Manual De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

IMPORT NT S FEGU RDS

When using your iron, basic safety precautions should always be
followed, including the following:
❑ rE d LL inSTrucTionS BEForE uSinG.
❑ use iron only for its intended use.
❑ To protect against a risk of electric shock, do not immerse the iron
in water or other liquid.
❑ The iron should always be turned to "oFF" before plugging into
or unplugging from an outlet. never yank cord to disconnect from
outlet; instead grasp plug and pull to disconnect.
❑ do not allow cord to touch hot surfaces. Let iron cool completely
before putting away. Loop cord loosely around iron when storing.
❑ lways disconnect iron from electrical outlet when filling with or
emptying of water and when not in use.
❑ do not operate iron with a damaged cord or if the iron has been
dropped or damaged. To avoid the risk of electric shock, do not
disassemble the iron, take it to a qualified serviceman for examination
and repair. or, call the appropriate toll-free number listed on the cover
of this manual. incorrect reassembly can cause a risk of electric shock
when the iron is used.
❑ close supervision is necessary for any appliance being used by or
near children. do not leave iron unattended while connected
or on an ironing board.
❑ Burns can occur from touching hot metal parts, hot water, or steam.
use caution when you turn a steam iron upside down or use the
surge of steam — there may be hot water in the water tank. void
rapid movement of iron to minimize hot water spillage.
7
SPECI L INSTRUCTIONS
❑ To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
❑ if an extension cord is absolutely necessary, a 15-ampere and
120-volt, or 7-ampere and 220-volt cord should be used. cords
rated for less amperage may overheat. care should be taken to
arrange the cord so that it cannot be pulled or tripped over.
S VE THESE INSTRUCTIONS.
POL RIZED PLUG (120V Models Only)
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended to fit into a polarized outlet only
one way. if the plug does not fit fully into the outlet, reverse the plug. if it still
does not fit, contact a qualified electrician. do not attempt to modify the plug in
any way.
T MPER-RESIST NT SCREW
Warning: This appliance is equipped with a tamper-resistant screw to prevent
removal of the outer cover. To reduce the risk of fire or electric shock, do not
attempt to remove the outer cover. There are no user-serviceable parts inside.
repair should be done only by authorized service personnel.
Note: If the power supply cord is damaged, it should be replaced by qualified
personnel or in Latin merica by an authorized service center.
8
Tabla de contenido
loading

Tabla de contenido