Idiomas disponibles
Idiomas disponibles
T
EMPERATURE
Trisensor Climate Control
(select models)
The control is located at the top front of the fresh food
compartment.
Control
Initial Temperature Setting
Temperatures are preset at the factory at 38° F (3° C)
in the fresh food compartment and 0° F (-17° C) in the
freezer compartment.
Adjusting the Control
24 hours after adding food, you may decide that one
or both compartments should be colder or warmer. If
so, adjust the control as indicated in the Temperature
Control Guide below.
• The first touch of the
current temperature setting.
• The display will show the new setting for
approximately three seconds, and then return to the
actual temperature currently within that
compartment.
• Do not change either control more than one degree
at a time. Allow temperature to stabilize for 24 hours
before making a new temperature adjustment.
Temperature Control Guide
Refrigerator too cold
Refrigerator too warm
Freezer too cold
Freezer too warm
Turn refrigerator OFF
All manuals and user guides at all-guides.com
C
ONTROLS
or
pads shows the
Set the Refrigerator control
to next higher number by
pressing the
pad.
Set the Refrigerator control
to next lower number by
pressing the
pad.
Set the Freezer control to
next higher number by
pressing the
pad.
Set the Freezer control to
next lower number by
pressing the
pad.
Press the Freezer
pad
until OFF appears in the
display. Press either the
Freezer or Refrigerator
pad to turn back on.
Speed Ice
When activated, Speed Ice reduces the freezer
temperature to the optimum setting for 24
hours in order to produce more ice. Important:
When the Speed Ice feature is in operation, the
and
pads for the freezer control will not operate.
Reset Filter (select models)
When a water filter has been installed in the
refrigerator, the yellow Order light will
illuminate when 90 percent of the volume of water for
which the filter is rated has passed through the filter
OR 11 months have elapsed since the filter has been
installed.
The red Replace light will illuminate when the rated
volume of water has passed through the filter OR 12
months have elapsed since the filter was installed. A
new filter should be installed immediately when the
Replace light is illuminated.
After replacing the filter, press and hold the Reset
Filter pad for three seconds. The Order and Replace
lights will go off.
Vacation Mode
The Vacation Mode feature causes the freezer
to defrost less frequently, conserving energy.
The Vacation Mode indicator light will
illuminate when the feature is activated. To deactivate,
press the Vacation Mode pad again OR open either
door. The indicator light will go out.
Notes:
• Door openings will not deactivate Vacation Mode
for approximately one hour after activation.
• If vacationing for more than a few days, see the
Preparing for Vacation section, page 25.
Temp Alarm
The Temp Alarm system will alert you if the
freezer or fresh food temperatures exceed
normal operating temperatures due to a power
outage or other event. When activated, the Temp
Alarm light will illuminate.
If the freezer or fresh food temperatures have
exceeded these limits, the display will alternately show
the current compartment temperatures and the highest
10
