Ibiza Light LSM900LED Manual De Instrucciones página 2

Maquina de humo de 900 w con led's

Idiomas disponibles

Please read this manual thoroughly and adhere to the instructions in order to avoid any danger or

damage due to misuse.

Thank you for purchasing this high quality, well-performing light effect IBIZA Light that will give you

entire satisfaction.

Remove package and check:

1. Open carton to check whether all necessary spare parts include accord the specification list. Please

contact distributor if there is something missing.

2. Check the appearance of machine and power line to see whether they have some obvious damage.

Please contact distributor once you find something and stop to use fog machine.

Installation:

1. Take away all packing material, specially the spray mouth.

2. Set in the horizontal direction and open the cover of liquid can.

3. Add high quality fog liquid in the machine and screw the cover of liquid can. Bad quality fog liquid will

damage fog machine.

4. Plug the remote control receiver into the remote control socket on the rear panel of the unit.

DISCONNECT DEVICE

Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect

device shall remain readily operable.

MOUNTING

Orientation

This fixture may be mounted horizontally only, provided there is adequate room for ventilation

RIGGING

It is important never to obstruct the fan or vents pathway. Mount the fixture in a level position using, a suitable

"C" or "O" type clamp.

When selecting installation location, take into consideration the ease of access to fill the tank and for routine

maintenance.

Safety cables must always be used.

Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes

or restricted ventilation.

If the external flexible cable or cord of this unit is damaged, it shall be exclusively replaced by the

manufacturer or his service agent or a similar qualified person in order to avoid a hazard.

Fuse replacement:

Warnings: Disconnect the power cord before replacing a fuse and always replace with the same type fuse.

With your hands, unscrew the fuse holder from its housing, remove the damaged fuse from its holder and

replace with exactly the same type of fuse. Screw the fuse holder back in its place and reconnect power.

Exterior surface temperature under steady state conditions is 60°C.

Ref.: LSM900LED

Page