Husqvarna YTH24K48 Manual De Operario página 23

Ocultar thumbs Ver también para YTH24K48:
Idiomas disponibles

Idiomas disponibles

SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 36)
MOWER DRIVE BELT REMOVAL
Park tractor on a level surface. En gage parking brake.
Lower attachment lift to its lowest position.
Disengage belt tension rod (K) from lock bracket (L).
CAUTION: Belt tension rod is spring
loaded. Have a firm grip on rod and
release slowly.
Remove screws (P) from mandrel covers (Q) and
remove covers.
Remove any dirt or grass clippings which may have accu-
mulated around mandrels and entire upper deck surface.
Remove belt from electric clutch pulley (M), both man-
drel pulleys (R) and all idler pulleys (V).
MOWER DRIVE BELT INSTALLATION
Install belt around all mandrel pulleys (R) and around
idler pulleys (V) as shown.
Install belt onto electric clutch pulley (M).
IMPORTANT: Check belt for proper routing in all mower
pulley grooves.
Reassemble mandrel covers (Q). Securely tighten all
screws.
Engage belt tension rod (K) on locking bracket (L).
CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and
engage slowly.
Raise attachment lift to highest position.
P
L
K
V
R
Q
P
M
R
R
Fig. 36
TO REPLACE MOTION DRIVE BELT
(See Fig. 37)
Park the tractor on level surface. En gage parking brake.
For as sis tance, there is a belt installation guide decal on
bottom side of left footrest.
BELT REMOVAL -
Remove mower (See "TO RE MOVE MOWER" in this
section of manual).
NOTE: Observe entire motion drive belt and position of all
belt guides and keepers.
Disconnect clutch wire harness (A).
Remove anti-rotation link (B) on right side of tractor.
Remove belt from stationary idler (C) and clutching
idler (D).
Remove belt from centerspan idler (E).
Pull belt slack toward rear of trac tor. Carefully remove
belt up wards from trans mis sion input pulley and over
cooling fan blades (F).
Remove belt downward from engine pulley and around
electric clutch (G).
Slide belt toward rear of tractor, off the steering plate
(H) and remove from tractor.
B
Q
A
23
C
D
E
F
02953
electric
Fig. 37
G
H
J
loading

Este manual también es adecuado para:

Yth24v48