Radio Code Programming (For Rsd-Sh1 Only) - Erreka RINO Serie Manual Del Instalador

PROGRAMMING AND STARTUP
3

RADIO CODE PROGRAMMING (FOR RSD-SH1 ONLY)


When using the ERREKA RSD-SH1 plug-in receiver (decoder-free receiver, trinary code, 433Mhz), the radio code
can be programmed in the control panel itself, as explained below. In other cases, follow the instructions of the
plug-in receiver used.

The programming of the radio in total and pedestrian opening are independent. Different transmitters can be
used with different codes.
Total opening code programming
Pedestrian opening code programming
60
Installation Guide
1 Connect the control panel power supply (SW1 in
ON).
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP4 in "ON"; DIP2, DIP3, DIP5 and
DIP6 in "OFF".

DL3 lights up.
4 Select the required code in the transmitter.
5 Press the channel to be used for total opening.

If programming has been carried out correctly,
DL2 flashes.
6 Place DIP1 and DIP4 in "OFF" (DL2 and DL3 will go
off).
7 Disconnect and reconnect the panel power supply.
1 Connect the control panel power supply (SW1 in
ON).
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP6 in "ON"; DIP2, DIP3, DIP4 and
DIP5 in "OFF".

DL3 lights up.
4 Select the required code in the transmitter.
5 Press the channel to be used for pedestrian opening.

If programming has been carried out correctly,
DL2 flashes.
6 Place DIP1 and DIP6 in "OFF" (DL2 and DL3 will go
off).
7 Disconnect and reconnect the panel power supply.