Idiomas disponibles
Idiomas disponibles
Connection to a Rain Sensor
The control unit can be connected a Claber Rain Sensor (code 90915). In
the event of rainfall, the watering programme will be suspended by the
rain sensor until the water in the sensor evaporates; the programme then
resumes automatically.
1. Break the connection between the yellow and grey wires, by cutting
the connection at the end.
1
2. Connect the yellow and grey wires to the wires of the rain sensor
Warning: if the rain sensor is not used, ensure that the yellow and grey
wires are joined together, restoring the connection if required.
yellow
grey
2
75 cm inclusive
max 30 m
30
All manuals and user guides at all-guides.com
.
2
1
Rain Sensor
90915
Fitting the battery
1. Unscrew the transparent cover
1
2. Unscrew the battery housing
3
3. Connect the battery, checking the correct polarity,
battery in the housing
.
5
4. Screw the cover on, checking that the seal is fi tted correctly in its
seat.
Warning: use only 9 volt alkaline batteries.
1
3
4
UK
and remove the control unit
.
2
.
and replace the
4
2
5
31
