Idiomas disponibles
Idiomas disponibles
AIR PURIFIER SET-UP
NOTE: Follow these instructions for
best results.
• Place unit at least 2 feet (½ meter) from
the wall.
• Keep unit away from drafty areas.
• Keep curtains away from unit, as they
may interfere with air intake/outlet.
• Place unit on a stable surface with plenty
of air circulation.
1. Remove protective film from the
control panel.
2. Open filter doors.
3. Take out filters and remove plastic
filter bags.
AeraMaxSV_412542_3L_021622.indd 6-7
4. Place filters HEPA-side-out and slide
them in until fully seated back in the
machine.
②
①
5. Close filter doors securely by inserting
the two tabs on the bottom of the door
first and then pivoting it closed. Repeat
for both doors.
6. Plug in the power cord to a wall outlet.
7. Turn unit on. Unit will beep, go into
AUTO mode, and display PM2.5
6
DISPLAY PANEL
PM2.5 indicator
3
1
2
Lock
Timer
Child lock key
Timer key
1. CHILD LOCK - Press the LOCK button for 3 seconds to activate the child lock function.
The child lock indicator LED will light up and all keys will be non-functional until unlocked
except the LOCK key.
Once locked, press the LOCK button for 3 seconds to deactivate the child lock function.
The child lock indicator LED will turn off and all keys will function normally.
2. TIMER - Press this button once to check the current status of a timer, which will display
hours left on screen. If there is no timer, the screen will display "OFF".
Continually pressing the TIMER button will select between timer settings from 1 to
12-hours in 1-hour increments to turn off the machine. Staying at a timer setting for 3
seconds will select it and the PM2.5 will again be displayed.
Continuing to press TIMER until the screen says "OFF" will cancel the timer. The timer
will also be turned off if the machine is powered down.
3. PM2.5 - this will light up when the display is showing the PM2.5 air quality reading.
4. DISPLAY - This display will show the MODE, TIMER, SLEEP and FILTER CHANGE
readouts.
5. CHILD LOCK INDICATOR
6. MODE - Press this button once to display the current machine mode. Continually press
it to cycle between fan speed 1, 2, 3, and 4, SLEEP mode, and AUTO mode. Stay at the
same mode for 3 seconds to select it and the PM2.5 will again be displayed.
In AUTO mode, the PM2.5 smart sensor will automatically select the fan speed based
on air quality readings.
At fan speed 1, 2, 3 or 4, the unit will run constantly at the corresponding speed.
In SLEEP mode, the purifier will run on fan speed 1, and all lights are off except a
dimmed power light.
7. POWER - When unit is plugged in, the unit will automatically enter standby mode and
the POWER button will be dimly lit.
Press this button when in standby mode to turn on the unit. All keys will light up and the
machine will go into AUTO mode if no other input occurs within 3 seconds.
While the unit is on, press this button to put the unit back into standby mode. The unit
will beep once during this process.
Child lock indicator
5
4
6
7
Mode
On/Off
Mode key
Power key
7
2/16/22 2:38 PM
