Idiomas disponibles
Idiomas disponibles
INSTALLATION
WARNING
Before installing, read the instruction carefully for your
safety and correct operation of the appliance.
CAUTION
To avoid personal injury or damages at least 2 people are
required for the installation.
What's in the Box
Make sure you have all the following items included in the
packaging. If any item is damaged or missing, contact your
dealer.
●
Refrigerator x 1
●
User Manual x 1
●
Warranty Manual x 1
●
Water Valve Connection x 1
●
Water Pipe [External diameter:1/4" (6.35mm) Length:98
7/16"(2500mm)] x 1
Installation and service must be performed by a
recommended installer, service agency or electric supplier.
Before First Use
●
Remove all packaging, including the foam backing at the
bottom of refrigerator and the tapes fixing accessories in
the box.
●
Place the refrigerator in a proper up-right position, let it
stand up-right for at least 4 hours before powering on.
●
Remove the film: There is a layer of transparent film on
the panel surface to protect it from being scratched. You
can choose to remove or leave the film as needed.
●
Review product specifications below to plan for proper
clearances in and around the enclosure.
Transportation
●
Do not carry the refrigerator horizontally or by laying it
down.
●
Do not carry the refrigerator by holding the door or
handle; the refrigerator shall be carried by lifting the
bottom.
●
This unit should never be moved alone, two people are
required to safely lift or move your unit.
Installation Dimension
●
Select a good location to place your appliance where it
is flat and easy to use. Avoid placing the unit near heat
sources,direct sunlight or moisture.
Dimension
A
35 7/8" (911 mm)
B
70 1/8" (1780 mm)
C
27 13/16" (706 mm)
D
24 1/2'' (622 mm)
E
15 1/2" (393 mm)
F
65 3/8" (1661 mm)
G
42 13/16" (1088 mm)
CCD-0007862 Rev: 05-16-23
E
●
The above figures are a guideline for installation
purposes. The actual dimensions of the unit may vary
slightly.
●
To ensure that your unit works at peak efficiency please
maintain sufficient space around your unit as outlined on
the next page.
Installation Preparation
Select Location
●
Your new refrigerator must stand on a flat surface which
should support a weight of 550lbs (250kg). Surface must
be level relative to the coach floor plane.
NOTE: A slope that is comfortable to live with, and from
normal transportation is acceptable.
●
If the appliance is to be placed onto the carpet, support it
with a wooden board. Do not place the appliance directly
on the carpet, as the heat from the compressor may
cause the carpet to fade.
- 5 -
E
F
