All manuals and user guides at all-guides.com
About This Guide
This installation guide provides basic
instructions for installing the DWL-6610APE
Unified AC Concurrent Dual-band PoE Access
Point on your network. For additional information
about how to use the Access Point, please see
the User Manual, which is available on the CD
included in this package or from the D-Link
support website.
System Requirements
- CD-ROM drive
- Windows
, Macintosh
®
system
- Ethernet port or installed Ethernet adapter
- Internet Explorer 7.0, Safari 5.0, Firefox 4.0, or
higher
Unpacking the Product
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- DWL-6610APE Unified AC Concurrent
Dual-band PoE Access Point
- Power adapter*
- 4 dual-band antennas
- Mounting ring
- Console cable*
- CD-ROM
- Ceiling bracket (3 sets, sizes are 9/16", 14/16",
and 1 1/2")
*The power adapter is an optional accessory and not
included in the package in some regions. To power
the units use a D-Link PoE switch or the D-Link
DPE-101GI PoE injector.
*The console cable is an optional accessory and
not included in the package in Armenia, Azerbaijan,
Belarus, Georgia, Israel, Kaliningrad, Kazakhstan,
Kyrgyzstan, Latvia, Lithuania, Moldova, Mongolia,
Russia, Turkey, Turkmenistan, Ukraine, and
Uzbekistan. If a cable is required, please contact your
reseller to order it (Model: ACS-AP-CONSOLE).
2 D-Link DWL-6610APE Quick Install Guide
, or Linux-based operating
®
Optional Accessories
- PoE base unit (Model: DPE-101GI)
Note: These accessories are not included in
the package. If any of these items are required,
please contact your reseller to order it.
Hardware Overview
LEDs
Figure 1. DWL-6610APE LEDs
POWER – When the LED is lit up, the
access point is powered and
ready for use.
LAN – When this LED is lit up, the
device's Ethernet port is
connected to an active router or
switch. The light will blink when
there is traffic going through the
port.
2.4GHz/5GHz – When the LED is lit up, the
access point's radio is enabled.
It will blink when there is wireless
traffic.
Interfaces
Power receptor
LAN port (PoE)
Figure 2. DWL-6610APE Rear Panel
Console port
