Idiomas disponibles
Idiomas disponibles
Accessories
Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
For U.S. models:
For optional accessories, please access our web site at:
www.hitachi.us/tv
Note : The accessories for models H4011, H4011A series are similar as the H401, H401A series.
1.
CAUTION:
2. This stand for use only with Hitachi P42H401, P42H401A, P50H401 and
3. The wall mount unit for the 50" and 42" models is WM07S and for the
³ Remote Control Unit CLU-4371UG2 (Part No HL02075 only H401 series)
Remote Control Unit CLU-4372UG2 (Part No HL02076 only H4011 series)
· Two "AA" size, 1.5V batteries .
» Table Top Stand (UX27661 42" model)
(UX27281 50" models).
¿ Power Cord (P# EV01841).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1.
Open the battery cover of the remote control by pushing down and sliding the back cover off.
2.
Insert two new "AA" size batteries for the remote control. When replacing old batteries, push them towards the
springs and lift them out.
3.
Match the batteries to the (+) and (-) marks in the battery
compartment.
4.
Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
5.
Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
4
·
Two "AA" size,
1.5V batteries
»
Table Top Stand
(50" included)
Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
P50H401A models. The use of other apparatus is capable of resulting in instability
causing possible injury.
55" models is WM07L. Please see page 7 for important information related
to the wall mount. Wall Mount unit is an optional accessory (Not Included).
¿
Power Cord
»
Note: Please visit our
website for optional
accessories.
´ Wire Clamp (50" models only)
Bottom View (Remote Control)
Lift up on tab to remove back cover.
´
Wire Clamp
(50" models only)
Table Top Stand
(42" included)
