Idiomas disponibles
Idiomas disponibles
The parts required to assemble and install the water
softener are included with the unit. Thoroughly check
the water softener for possible shipping damage and
parts loss. Also, inspect and note any damage to the
shipping carton.
Bypass Valve
Water Conditioning Information
IRON
Iron in water can cause stains on clothing and plumbing
fixtures. It can negatively affect the taste of food,
drinking water, and other beverages. Iron in water is
measured in parts per million (ppm). The total* ppm of
iron, and type or types*, is determined by chemical
analysis. Four different types of iron in water are:
= Ferrous (clear water) iron
= Ferric (red water) iron
= Bacterial and organically bound iron
= Colloidal and inorganically bound iron (ferrous or
ferric)
Ferrous (clear water) iron is soluble and dissolves in
water. This water softener will reduce moderate
amounts of this type of iron (see specifications).**
Ferrous (clear water) iron is usually detected by taking
a sample of water in a clear bottle or glass.
Immediately after taking, the sample is clear. As the
water sample stands, it gradually clouds and turns
slightly yellow or brown as air oxidizes the iron. This
usually occurs in 15 to 30 minutes.
When using the softener to reduce Ferrous (clear
water) iron, add 5 grains to the hardness setting for
every 1 ppm of Ferrous (clear water) iron. See "Set
Water Hardness Number" section.
Ferric (red water), and bacterial and organically bound
irons are insoluble. This water softener will not remove
Inspect Shipment
Packing List
(shipped installed on
Drain Hose
the softener's valve)
Water Hardness
5
Remove and discard (or recycle) all packing materials.
To avoid the loss of small parts, we suggest you keep
the small parts in the parts bag until you are ready to
use them.
Clips
Hose Clamps
Test Strip
Silicone Grease
ferric or bacterial iron. This iron is visible immediately
when drawn from a faucet because it has oxidized
before reaching the home. It appears as small cloudy
yellow, orange, or reddish suspended particles. After
the water stands for a period of time, the particles
settle to the bottom of the container. Generally, these
irons are removed from water by filtration. Chlorination
is also recommended for bacterial iron.
Colloidal and inorganically bound iron is of ferric or
ferrous form that will not filter or exchange out of
water. This water softener will not remove colloidal
iron. In some instances, treatment may improve
colloidal iron water. Colloidal iron water usually has a
yellow appearance when drawn. After standing for sev-
eral hours, the color persists and the iron does not set-
tle, but remains suspended in the water.
SEDIMENT
Sediment is fine, foreign material particles suspended
in water. This water softener will not remove sediment.
This material is most often clay or silt. Extreme
amounts of sediment may give the water a cloudy
appearance. A sediment filter installed upstream of the
water softener normally corrects this situation.
* Water may contain one or more of the four types of
iron and any combination of these. Total iron is the
sum of the contents.
** Capacity to reduce clear water iron is substantiated
by laboratory test data.
Adaptor Elbow
Grommet
FIG. 2
