Idiomas disponibles
Idiomas disponibles
Warning: Incorrect parameters setting will cause poor wash quality or detergent residuals on the crockery, even
after rinsing.
3.8 Detergent activation
Use keys
B
(increase) and
Pressing the key
Start F,
checking if detergent fl ows out the wash chamber injector.
This function serves to load the detergent circuit at the start up or during the normal use, when the detergent in the tank is
fi nished and the circuit emptied out.
3.9 Rinse-aid activation
Use keys
B
(increase) and
Pressing the key
Start F,
This function serves to load the rinse-aid circuit at the start up or during the normal use, when the rinse-aid in the tank is
fi nished and the circuit emptied out.
At maximum speed, the dosing pump takes about 40 seconds to fi ll the empty circuit.
3.10 Water hardness setting (optional)
This parameter is visible and adjustable only on those models equipped with the optional built-in
at the start-up (see paragraph 5.4).
The right water hardness value is fundamental for a proper functioning of the automatic regeneration cycle.
Use keys
B
(increase) and
key
Start
F.
This parameter allows setting the inlet water-hardness range. Before setting this parameter a proper measurement of the
water hardness is needed.
Water hardness
Low 10-15°f
Medium 15 - 20°f
Med/high 20 - 25°f
High 25 - 35°f
Warning: Incorrect parameter setting can cause a limestone accumulation that, long term, can compromise the
machine performances.
3.11 Anti-fl ooding sensor (optional)
Use keys
B
(increase) and
the key
Start
F.
This parameter activates the optional anti-fl ooding sensor in case the machine is equipped with a fl oat sensor, installed at
the bottom of the machine.
Warning: Do not activate this parameter if the sensor is not connected, because the machine would continuously
generate an alarm.
SERVICE MENU
YES
NO
Anti-fl ooding sensor
C
(decrease) to select the parameter
until it turns on green, the detergent dosing pump is activated. Verify the injection inside the tank,
C
(decrease) to select the parameter
until it turns on green, the rinse-aid dosing pump activates.
C
(decrease) to select the parameter
It is possible to select one of the following four parameters:
LOW 10 - 15°f
MEDIUM 15 - 20°f
MED/HIGH 20 - 25°f
HIGH 25 - 35°f
Use keys
selection by pressing the key
C
(decrease) to select the parameter
Use keys
selection by pressing key
Detergent
Rinse-aid
Water
hardness. Confi rm the selection by pressing the
(5 - 8°d)
(8 - 11°d)
(11 - 14°d)
(14 - 20°d)
B
(increase) and
C
(decrease) to select the desired value. Confi rm the
Start
Anti-fl ooding
B
(increase) and
C
(decrease) to select the desired value. Confi rm the
Start
F.
activation.
activation.
Water Softener,
F.
sensor. Confi rm the selection by pressing
EN
enabled
page 39
