Sinbo SSI 2876 Instrucción Del Uso página 11

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
by altering its physicochemical characteristics.
Do not use chemical additives, scented substances or decalcifiers. Failure to comply with the
above-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point where no
more steam comes out, but rather drops of boiling water that can leave marks or stains. In
these cases, the Anti-drip system automatically activates to prevent vaporization, so that you
can iron the most delicate fabrics without risk of spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. eight minutes in the
upright position or unused for approx. Thirty seconds in the horizontal position. The light comes
on to indicate that shut off has tripped. As soon as you move the iron, the device turns off and
the iron starts working again.
GENERAL INSTRUCTIONS
When using the iron for the first time, you may notice a slight emission of smoke and hear some
sounds made by the expanding plastics. This is quite normal and it stops after a short time. We
also recommend passing the iron over an ordinary cloth before using it for the first time.
Suggestions before using the iron for the first time
1. Certain parts of the iron have been lightly greased therefore the iron could give off a little
smoke when plugged in for the first time. This will cease after a short while.
2. Before using the iron for the first time, remove the plastic protector from the base (if it has
one) clean the base with a soft cloth.
3. Keep the base very smooth. Do not run it over metal objects (such as against the ironing
board, buttons, zips etc.)
4. Pure wool fibres (100% wool) can be ironed with the appliance in the steam position by
preference ,select a high steam position and use a dry ironing cloth.
Selecting the temperature
1. Check the ironing instructions on the garment to be ironed.
2. If the garment does not have any ironing instructions but you know the kind of fabric in
question, use the chart below.
3. Fabrics that have some kind of finish (polishing, wrinkles, contrasts....) can be ironed at the
lowest temperatures.
4. If the fabric contains several kinds of fibres, always select the temperature applicable, if an
article contains 60% polyester and 40% cotton ,you must always choose the temperature
corresponding to polyester and without steam.
5. First classify the articles to be ironed according to the most suitable ironing temperature:
wool with wool, cotton with cotton, etc. as the iron heats up as fast as it cools, start by ironing
the articles requiring the lowest temperature such as those made of synthetic fibres. Progress
towards those that require the highest temperatures.
6. Turn the temperature control until it is in front of the appropriate signal according to the
following:
- 10 -
loading