Cisco SF350-24P Guia De Inicio Rapido página 4

To install the switch into a 19-inch standard chassis:
Place one of the supplied brackets on the side of the switch so that
S 1
TEP
the four holes of the brackets align to the screw holes, and then use
the four supplied screws to secure it.
Repeat the previous step to attach the other bracket to the opposite
S 2
TEP
side of the switch.
After the brackets are securely attached, the switch is now ready
S 3
TEP
to be installed into a standard 19-inch rack.
Wall Mounting
Most of the 350 Series Cisco switches include wall-mounting slots on the
bottom of the device.
Insecure mounting may damage the device or cause injury.
W
ARNING
Cisco is not responsible for damages incurred by insecure wall
or ceiling mounting.
To mount your switch to a wall:
Determine where you want to mount the device. Verify that the
S 1
TEP
surface is smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface of the wall 94 mm apart.
S 2
TEP
Insert a screw into each hole, leaving a gap between the surface S 3
TEP
and the base of the screw head.
4 Cisco 350 Series Managed Switches