Idiomas disponibles
Idiomas disponibles
13.6 Charging
-Make sure that the Electric scooter, charger, and DC power input of the device are always
dry.
-Note: To charge this Electric scooter, use SOLELY the supplied charger with the following
output: 42 V -1.5A.
-Using a different charger may cause damage to the device and other potential risks.
-Use the mains adapter to plug the DC input of the device into a conventional socket.
-There will be no light on the charger before charging, when connected to e-scooter the
adapter will light red, and charging has started.
-The red indicator lights up when properly charged; if this is not the case, please check the
connections.
-Now you can stop the charging cycle. Overcharge shortens the battery life.
-The charging process takes up to 3 hours. Do not charge the battery for more than 3
hours. After 3 hours, disconnect the charger from the device and the power supply.
Overcharge reduces the battery service life.
-The product must not be charged over extended periods.
-Always keep an eye on the device throughout the charging cycle.
-Charge the device only at temperatures between 0 °C and +45 °C.
-When charging at lower or higher temperatures, there is a risk that the battery
performance will be reduced. Therefore, there is a potential risk of injuries and material
damage.
-Store and charge the device in an open, dry area away from combustible materials.
-Do not charge the device in direct sunlight or in the vicinity of open flames.
-Do not charge the device immediately after use. Allow the device to cool down for an
hour before charging it.
-If the device is left to other people, it must be charged partially (20 - 50%), not fully.
-Do not remove the device from its package to fully charge it and then put it back in the
package.
-The device is generally partially charged as shipped from the factory. Keep the device
partially charged until it is used.
-Allow the Electric scooter to cool down for at least 1 hour before it can be put in the
package.
-Do not leave the device exposed to sunlight in a car.
CAUTION
The Electric scooter must not be used during the charging cycle!
-The LED indicator on the battery charger lights red during the charging process.
-The LED indicator on the charger will light green when the charging process is complete.
-After charging, disconnect the charger from the mains and the Electric scooter.
CAUTION
Connect the DC cable supplied with the Electric scooter only to the DC input!
-Do not insert foreign objects into the DC input.
CAUTION
-Do not remove the protective cap from the DC input!
-Remove the cap only when charging the Electric scooter!
-After charging, disconnect the DC plug and close the DC input again with the cap!
