Idiomas disponibles
Idiomas disponibles
EN. MANUAL
Read and keep these instructions. Please read this manual carefully before using the product. Protect and
protect others by heeding all safety warnings and precautions. Failure to follow the instructions may result
in personal contact and/or damage to the product's property. Save the instructions for future reference.
CAUTION: Operation of this machine is commented that a reactive torque
may occur when the rotary auger comes into contact with hard debris.
Therefore, a firm grasp with both hands.
Specific safety instructions
Petrol engine
- Gasoline or diesel engines must never be used in unventilated or enclosed areas.
The exhaust fumes are very dangerous and can cause "carbon monoxide poisoning" which can
cause drowsiness and death.
- The motor must not run at speeds exceeding the maximum stated on the nameplate. Running
an engine at too high speeds increases the risk of personal injury.
- Do not tamper with components that may increase or decrease the controlled speed.
- Never run the engine unattended near a building or near a tarpaulin or plastic structure,
such as tents, etc.
- Always use the correct fuel as stated in the owner's manual and on the nameplate.
- To avoid fire, always switch off the engine when refueling and never overfill the fuel tank.
- Always clean up spilled fuel with sand immediately.
- Do not run the engine in or near an explosive atmosphere.
- Periodically check the fuel system for leaks. Seals and hoses should be checked for signs of
wear or tear. Check for loose or missing clamps, damaged fuel tank or filler cap.
All detections must be corrected for further use.
- Do not let the engine run out of fuel.
- Before transporting in a vehicle, drain all fuel to avoid leakage.
- Store the engine in a well-ventilated area with an empty fuel tank.
AUGER
- Before using the auger, the operator must be aware of the manufacturer's safety and
operating instructions. The machine may only be operated by a trained person.
- Only use the auger in daylight or good artificial light.
- Always start the auger carefully with your feet far from the drill bit.
- Do not leave the auger unattended when the engine is running.
- Do not use the auger barefoot or in open-toed sandals.
Always wear appropriate clothing, gloves and safety shoes.
- Only use the drill in the ground, not for drilling holes in too rocky ground.
- Do not drill holes in an area where there may be hidden gas and water pipes or electricity
and other cables.
- Make sure that the chuck is firmly attached to the gearbox output shaft.
- Do not use a damaged or worn drill bit.
- Do not carry the drill with the engine running, the drill bit should not rotate when the engine
is idling.
- Keep hands and feet away from the rotating drill bit at all times.
- Always make sure the engine is turned off and the spark plug cap is removed before making
any adjustments.
- Before using your auger, always visually inspect it to see if any parts are present or damaged.
- Replace damaged parts before using the machine.
33
