Hilti Nuron SL 10-22 Manual De Instrucciones Original página 26

come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage of cordless power tools and batteries
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
10.1 Shoulder strap
CAUTION
Inadequate fastening presents a hazard! The shoulder strap disengages and the tower light drops down.
▶ When you use the shoulder strap, make sure that it is correctly secured to the tower light.
The tower light can be transported easily and conveniently with the shoulder strap.
▶ Hook the shoulder strap into the eyelets for the shoulder strap. Check that it holds securely.
11 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery → page 15.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
Tower light tends to topple or
is unsteady.
LEDs of the battery show
nothing
20 English
Possible cause
Tripod legs not locked.
Tower light set up on a surface that
is not level.
Rubber feed faulty/worn.
Supply cord pulled taut.
Battery faulty.
Action to be taken
▶ The carrying handle must
engage with an audible click
when the tripod legs are
extended. → page 17
▶ Set up the tower light on a level
surface.
▶ Replace the rubber feet. → page 19
▶ Route the supply cord in such
a way that it does not present a
trip hazard. → page 18
▶ Route the supply cord in such a
way that it is not pulled taut.
▶ Contact Hilti Service.
2384868
*2384868*