Idiomas disponibles
Idiomas disponibles
Please read this user guide before installing and using your power distribution Center.
INTRODUCTION
The integrated USB center can connect up to
two devices, such as a digital camera, MP3
player, tablet or cell phone.
SPECIFICATIONS
cULus listed, rated for: 120 V ac, 2.1 A, 60 Hz
Product: I.T.E power supply
Model No: GEO101U-050210U
Company: Whalen Furniture Manufacturing
NOTES
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced
radio/TV technician for help.
User Guide
Need Assistance? Visit us at: samsclub.com
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CAN ICES-003(B) / NMB-003(B)
This Class B digital apparatus complies with
Canadian ICES-003.
Whalen Furniture
1578 Air Wing Road, San Diego, CA 92154, USA
1-866-942-5362
WARNINGS
! Your hub automatically shuts off any port
with a low or excessive current.
! If USB Hub Current Limit Exceeded appears
on your screen, disconnect the affected
USB device, click Reset on the screen, and
reconnect the device.
! If one of your hub ports is disabled, but USB
Hub Current Limit Exceeded does not
appear:
Disconnect and reconnect the affected
device.
If the port still does not work, disconnect
the hub and the device, and then
reconnect.
! Keep your USB hub dry; if it gets wet, wipe it
dry immediately.
! Do not modify or tamper with your hub's
internal components. It may cause a
malfunction and invalidate its warranty.
CAUTION: Changes or modifications not
expressly approved by the party responsible
for compliance could void user's authority to
operate the equipment.
5 |
P a g e
